Mitsubishi Electronics Mitsubishi Digital Electronics Portable Multimedia Player GOT1000 用户手册
8 - 38
8. ETHERNET CONNECTION
8.4 PLC Side Setting
8.4 PLC Side Setting
8.4.7
Connecting to Ethernet
module (FX Series)
module (FX Series)
This section describes the settings of the GOT and
Ethernet module (FX Series) in the following case of the
system configuration.
Ethernet module (FX Series) in the following case of the
system configuration.
POINT
POINT
POINT
Ethernet module (FX Series)
For details of the Ethernet module (FX Series), refer to
the following manual.
For details of the Ethernet module (FX Series), refer to
the following manual.
FX
3U
-ENET User's manual
FX
3U
-ENET-ADP User's manual
System configuration
*1
These setting items do not exist at the PLC side. However,
the virtual values must be set on the GOT side.
the virtual values must be set on the GOT side.
Ethernet parameter settings of FX
Configurator-EN
(1) Ethernet settings
Set the Ethernet parameter with FX Configurator-EN.
For using FX Configurator-EN, install GX Developer Ver.
8.25B or later on the personal computer.
For details on FX Configurator-EN, refer to the following
manual.
For using FX Configurator-EN, install GX Developer Ver.
8.25B or later on the personal computer.
For details on FX Configurator-EN, refer to the following
manual.
FX Configurator-EN Operation manual
:Required :Set if necessary :Not required
*1
Set the number of the Ethernet module.
<GOT>
(The settings other than the
following are set to the default)
(The settings other than the
following are set to the default)
PLC No.
: 1
IP address
:
192.168.0.18
Port No.
: 5019
Communication
format
format
: TCP (fixed)
PC No.
: 2 (virtual)
Network No.
: 1 (virtual)
IP address
: 192.168.0.19
Port No.
: 5551
Communication
format
format
: TCP (fixed)
<Ethernet module> (The settings other than the
following are set to the default)
following are set to the default)
*1
*1
■
Item
Setting
Setting
(with GOT connected)
Module
Module 0
*1
Operational settings
Refer to (2)
Initial settings
(Use default value.)
Open settings
Refer to (3)
Router relay parameter
(Use default value.)
E-mail settings