Microboards Technology CWR-424-52 用户手册

CWR-424-52

Microboards Technology LLC

Setting up the CWR-424-52 duplicator

Set up the CWR-424-52 duplicator with the following conditions:

• 19” Rack mount position or
•

On a level and stable surface

•

In a well ventilated location

•

Temperature and humidity:

o Temperature: 5-40° C
o Humidity: 20-80%RH (no dew formation)

Do not locate the CWR-424-52 duplicator:

Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by
a curtain or blind.)

In a place where there is a lot of vibration

Near open flame

In a place where the temperature and humidity change drastically

Near a heating device such as a heater or furnace

In a location where air from an air conditioner blows directly onto the unit

Near a container filled with water such as a vase

In a dusty location

Dust and dirt can decrease the productivity of the duplicator dramatically. It is very
important to keep the system in a clean and dust free environment.

In winter during times of low humidity or in a location where static electricity is

generated, use an anti-static-electricity mat or humidifier to prevent static electricity

Copy Process

The advantage of the CWR-424-52 is the quick and easy operation to burn CD information.

You can burn CD-R’s by pressing the button only once with the CWR-424-52 as follows;

Turn on CWR-424-52, and it begins to initialize.

o The LED’s turn on, one at a time and then go off, leaving the 1

mode light on.

o  Insert a Master disc into the Master drive and blank discs into writers.
o  Wait for ten seconds until the drives are ready.
o  Press the ‘START’ button (press it once).
o  The copy process begins.

Refer to the “LED’s Status” and “Copy Mode Process” sections for details.

Using Audio Masters:
When copying Audio masters with a large number of tracks, the system can take 3 to 5 minutes to