Meridian Audio Digital Surround Controller G61 用户手册

To connect to other Meridian G Series, 500 Series, or 800 Series equipment

#/--3

In a system of Meridian products the products should be linked

together in a chain, via the COMMS sockets, using the Comms

leads supplied with each product. The sequence in which you

connect the units is not important.

One of the products acts as the controller for the system, receiving

infra-red commands from the MSR+, and then, if appropriate,

relaying them to the other products via the Comms link. The

following procedure should be used to set up the Comms correctly

between several products:

• Switch all the units to standby.

• Press Clear (MSR+).

Each unit will display:

Auto

One unit will then be designated as the controller, and display:

Con.

All the other units will be configured as non-controllers, and

display:

Not Con.

The system is now ready for use.

If the automatic setup does not work, first make sure you are

operating the MSR+ from a position where all the units can receive

the infra-red, and try again. Then:

• Check that none of the units have been configured to be IR

Controller; see

products should be set to Auto, or one should be configured as

Controller and the others as Not Controller.

Note: Do not, under any circumstances, connect any equipment

other than Meridian G Series, 500 Series, or 800 Series to any

socket marked COMMS on the back of the product.

I n s t a l l i n g t h e

d i g i t a l s u r r o u n d

c o n t r o l l e r

1 4