Cirkuit Planet MH-2001 用户手册

MH-2001 Multi-Homing Security Gateway User’s Manual 

HTTP: Select this to allow the device WebUI to be accessed from the WAN network. This will allow the WebUI 

to be configured from a user on the Internet. Keep in mind that the device always requires a username and 

password to enter the WebUI. 

 

If you want to connect WAN 2 to another ISP connection, click Modify button of WAN No. 2 then repeat above 

procedures to setup.   

 

Depends on your network requirement, you can disable the DMZ port, make DMZ port transparent to WAN 1 or 

enable NAT function on it.   

To configure the DMZ port, select the Interface tab on the left menu, then click on DMZ, the following page is 

shown. 

 

Please refer to Section 2.2 for select the mode you need and configure relative IP parameters. 

 

Click on the Policy tab from the main function menu, and then click on Outgoing (LAN to WAN) from the 

sub-function list.   

Click on New Entry button. 

When the New Entry option appears, enter the following configuration:   

Source Address – select “Inside_Any” 

Destination Address – select “Outside_Any” 

Service - select “ANY” 

Action - select “Permit, ALL” 

Click on OK to apply the changes. 

 

 

 

 

- 11 -