Maretron M001101 用户手册

 

end of the cable to the RAA100 (note the key on the male connector and keyway on the 
female connector). Be sure the cable is connected securely and that the collar on the cable 
connector is tightened firmly. Connect the other end of the cable (male) to the NMEA 2000

®

 

network in the same manner. The RAA100 is designed such that you can plug or unplug it 
from an NMEA 2000

®

 network while the power to the network is connected or disconnected. 

Please follow recommended practices for installing NMEA 2000

®

 network products. 

 

 

The RAA100 has several configurable parameters, which are shown below including the 
default values. If you are not using the default values, then you will need to refer to the 
corresponding section for configuring the RAA100 appropriately. 
 

1.  Rudder Instance Number – Default is Rudder Instance #0 (Section 3.1) 
2.  Operating Mode – Default is NMEA 2000

 Mode (Section 3.2) 

3.  Resistive Sender – Default is American standard (Section 3.3) 

 
In addition to configurable parameters, the RAA100 can be calibrated for standard resistive 
senders (i.e., American standard 240-30 ohm, European standard 10-180 ohms) with 
maximum rudder angles of 45°, or the RAA100 can be custom calibrated for any sender or 
maximum rudder angles. Refer to Section 3.3 for choosing a standard type resistive sender or 
custom calibrating the RAA100. 
 

As shipped from the factory, the RAA100 transmits the Rudder Instance Number as “0”. The 
NMEA 2000

®

 network supports up to 252 rudders (0 through 251).  The RAA100 is configured 

or programmed by choosing a RAA100 rudder instance number using a display product such 
as the Maretron DSM200. Refer to the user’s manual for configuring the RAA100 as the 
manual provides detailed instruction on configuration procedures.