Intex Recreation HT30220 用户手册

(114)  ELECTRIC POOL HEATER  ENGLISH  7.5” X 10.5” PANTONE 295U  

12/18/2006

• Plug in the power cord.

• Switch the knob clockwise to the "I" 

position to turn the electric pool 
heater on.

• Re-plug the GFCI/RCD and press the 

“RESET” button.

• The temperature sensor will cut off the

power of heater when the water 
temperature is above approximately 
95oF (35oC). It continues to work 
when the water temperature drop 
below approximately 82oF (28oC).

• Turn on the filter pump.

• Ensure the plunger valves are opened

(if any).

• Ensure your filter cartridges are clear 

from debris and dirt.

• Release all trapped air in the 

circulation line.

• Check for the direction of water inlet 

and water outlet hose. Reverse the 
hose if necessary.

• Always use the solar cover if the pool 

is not occupied.

• Increase the heating time properly.

• Stop the heater and shorten the 

heating time.

• Tighten/reinstall hose clamps.

• Reposition/replace hose seals.

• Unplug the GFCI/RCD and then 

re-plug in and press the “RESET”
button to start the heater. Contact 
Intex Service Center if it trips off 
continuously.

THE RED 
INDICATOR DOES
NOT LIGHT UP
DURING USE.

THE WATER 
TEMPERATURE
DOES NOT
INCREASE
ALTHOUGH THE
RED INDICATOR IS
LIT UP.

THE WATER 
TEMPERATURE IS
TOO HIGH.

HOSE LEAKING

GFCI/RCD KEEPS 
TRIPPING OFF.

1. The power cord is not 

plugged in.

2. The knob is not fully switched 

to on position – “I”.

3. The GFCI/RCD plug is not 

turned on.

4. The water temperature is too 

high.

5. No water flow.

6. Low water flow.

1. Pool or solar cover not been 

used.

2. The pool size or water capacity

exceeds the heater capacity.

3. The water temperature is too 

low.

1. Heating time too long.

1. Hose clamps.

2. Hose seals.

1. Product failure or electrical 

circuit problem.

• The white inserts at both ends of the hoses shall remain inside and shall be 

firmly inserted in the hose. Do not remove the white inserts from the hoses.
These white inserts are not serviceable parts.

• To facilitate the connection of the hoses into the black protruding hose 

connectors on the pool wall, you may use soapy water solution (mix 6 drops 
of dish detergent in 1/2 a cup of water) to lubricate the inserts by simply 
dipping the hose ends into the solution. Continue per owner’s manual.

• Do not use lubricants such as machine or industrial oil or grease.

HOSE

INSERT