Intermec 751G 用户手册

If you have at least one device in your 751G (radio, scanner, or imager), the 
battery power fail level is set so that after the system shuts down in a low 
battery condition, there is still sufficient charge to allow the unit to remain 
configured, keep proper time, and maintain DRAM (Dynamic Random 
Access Memory) for at least 72 hours at room temperature if the main 
battery remains in the mobile computer. 

The configuration and time are lost if:

• The battery discharges beyond this level.

• The battery is removed when the computer is not in suspend mode.

• A cold-boot (reset) is performed on the computer.

Make sure you fully charge the battery before you use your 751G. To 
charge the battery, you need to install it in the 751G.

Remove the two thumb screws on the connector cover to release the 
hand strap and back cover.

Slide the bottom of the strap forward to release it from the retaining slot.

Tilt, insert, and place the battery into the compartment. Make sure the 
battery compartment latch clicks in place to ensure the battery is secure.

Insert your 751G into its single dock for charging.

Thumb screws

Retaining slot

Battery compartment latch

Battery compartment

Battery pack