Intel SR1500AL 用户手册

48

8. If you need to add or replace a PCI add-in card, see 

“Installing and Removing a PCI 

Add-in Card”

.

9. If you need to add or replace a PCI riser connector, see 

“Replacing a PCI Riser 

Card”

.

10. If you removed the PCI riser assembly for another procedure, continue with that 

procedure.

1. Lower the riser assembly into place (see letter “A”).

2. Align the four hooks in the riser assembly with the matching slots at the back of the 

server system (see letter “B”).

3. Press down uniformly until the four hooks on the rear of the PCI riser assembly 

engage the server system back panel slots. The riser cards will seat into the 
matching sockets on the server board.

4. Lock the retention clip as shown in the figure (see letter “C”).

5. Connect any cables to add-in cards that require them. See your add-in card 

documentation for information and add-in card requirements.

6. Re-install the processor air duct. For instructions, see 

“Installing the Processor Air 

Duct”

.

7. Install the server system cover. For instructions, see 

“Installing the System Cover”

. 

8. (Optional) Install the front bezel. For instructions, see 

“Installing the Front Bezel”

. 

9. Plug all peripheral devices and the AC power cable(s) into the server.

AF000363

A

B

C