Husqvarna Pole Saw FS 1000 E 用户手册

9

The FS 1000 EM floor saw has a lifting eye, which must be

used when lifting the machine. Don't lift using any other parts,

as this could cause damage to the machine and personal injury.

If using a lifting strap, attach it to the lifting eye so that the

machine cannot tip over during lifting. See figure 7.1. When

transporting the floor saw, apply the parking brake and use

anchor straps or the like to prevent it from moving about. See

figure 7.3.

Figure 7.1

7.1.1. Lifting eye

Figure 7.2

7.2. Parking brake off

Figure 7.3

7.3. Parking brake on

Blade turns wrong way.

Phases from power cable are inverted.

Change polarity

using phase inverter.

Drive belt is slipping.

Belt is too slack.

Adjust belt tension. 

Drive belt is worn.

Replace the drive belt.

Drive belt is oily.

Clean the drive belt.

Motor cuts out.

Cutting depth too large.

Reduce cutting depth.

Cutting speed too high.

Advance more slowly.

Diamond segments are worn.

Replace diamond blade.

Blade gets jammed.

Support floor from below 
using props or a jack.

No cooling water.

Nozzles are blocked.

Clean nozzles.

Water pressure too low.

Increase water pressure.

Blade gets jammed.

Blade is worn.

Replace blade.

Blade gets jammed.

Support floor from below 
using props or a jack.

Motor does not start.

Electrical fault.

Contact your electrician.

Emergency stop activated.

Determine cause. When fault is 
fixed, pull up emergency stop.

WARNING!  Before attempting to fix a fault you must make

sure that the power cables are disconnected to prevent the

machine from starting up while you are working.

If there is a fault with the machine check first whether it

matches any of the faults described in the troubleshooting

chart below.

If you cannot localise the fault and it does not match any of the

faults described in the troubleshooting chart you should

contact your supplier for additional information.

1

NOTE! Do not start the machine before rectifying the cause of the fault.