Hummingbird Communications Humminbird 200DX Dual Beam 200DX 用户手册

USING THE 200DX

USING THE 200DX

Actual depth capability depends on factors such as bottom hardness, water conditions,
and transducer installation. Unit will typically read to deeper depths in fresh water than
in salt water

The 200DX contains a simulator that allows you to use the unit
as if you are on the water. The simulator is invaluable or
learning how to operate the 200DX.

There are two ways to start the simulator. If the unit is powered
off, press and hold the POWER button for approximately three
seconds until you hear a continuous chirp.

The simulator can also be started by selecting the Simulator option on the start-up
screen after you power-up the unit. When this screen is shown, simply press the DOWN
ARROW until Simulator is highlighted. When the screen times out, the unit will be in
simulator mode.

When in simulator operation, the 200DX responds to control inputs as if it is in actual
operation, so feel free to experiment or to customize the unit for your particular
operation.

To exit Simulator mode, power the unit off.

If your 200DX is installed with a transducer connected, any changes you make to the
set-up or User Options (see Control Functions) while in Simulator are retained in the
unit memory. This allows you to use simulator to experiment with the various set-up
options and retain your selected settings for normal operation.