Husqvarna Grinder SG13B 用户手册

LUBRICATION

44 - 

HUSQVARNA

The engine should be warm (but not hot) when 

changing the oil. Warm oil flows out faster and leaves 

a smaller quantity of old oil inside the engine.

Place a suitable container underneath the oil 

1. 

drainage screw. Remove the oil dipstick and the oil 

drainage screw on the back surface of the engine.
Tip: Make a channel using a piece of cardboard 

to lead the oil directly into the container to avoid 

soiling the machine chassis.
Allow the engine oil to drain into the container; 

2. 

then replace the drainage screw. Tighten it 

moderately.

Make sure the machine is parked on flat ground. 

3. 

Fill with new oil using the appropriate viscosity 

according to the diagram, API Service  SF-SG, 

to the upper level mark on the dipstick = threads 

on the oil dipstick. The engine takes 1.16 qts. 

(1.1 liters) of oil. When checking the oil level, the 

dipstick should 

not be screwed in.

Check that the rubber gasket is in position and 

4. 

screw the dipstick back into place. DO NOT 

tighten it askew or too hard or you may damage 

the threads.
Wipe up any spilled oil.

5. 

8060-028

8011-046

8011-187