HP STORAGEWORKS SSL1016 用户手册

Installation and Configuration

Daisy Chaining

The autoloader does not support daisy chaining with other products. You can
daisy chain one additional autoloader using the 68-pin VHDCI connector to
68-pin VHDCI connector 3 foot (.092 meter) cable. You must then install a
terminator on the second autoloader.

Ethernet Connection

Attach one end of the RJ-45 cable to the autoloader. Attach the other end to a
10/100 hub or switch.

Note:

This step is not required for operation, but is necessary if you want to use the

autoloader Web administration feature.

Power On

Carefully inspect your power cord and make sure that it is the correct one for your
country or region. If the power cord is not correct, contact your customer service
representative.

To connect the power cord:

1. Make sure that the power switch on the back of the autoloader is off (the 0 is

pressed).

2. Connect the female end of the power cord to the power connector on the back

of the autoloader.

3. Plug the male end of the power cord into the power source.