HP C4381-90100 用户手册

1-8

If You Have Problems

If You Have Problems

After connecting your CD-Writer Plus drive and turning on your
computer, the computer should start (boot) as it normally does. If it does
not, check the following items:

■

Is the computer power plugged in?

■

Is each device plugged in and turned on?

■

Are all cables properly plugged into the back of your computer and
the CD-Writer Plus drive?

■

Try turning off your computer. Wait at least 20 seconds before turning
it back on.

Installing the Software for Windows 95 or
Windows NT 4.0

After the CD-Writer Plus drive is attached to your computer, you are
ready to install the application software.

NOTE: You must run the installation program. The installation program
converts the files from the CD into a usable format.

If your computer DOES NOT have a CD-ROM drive:

1. To get your CD-Writer Plus started right away, insert the diskette labeled

Driver Installation into your floppy drive.

2. Click the Start button on the task bar, select Run.

3. Type

A:\SETUP

(where A: is your floppy drive’s letter), and press

ENTER

The parallel port driver files are installed. This may take several minutes
and your mouse cursor will not move.

4. Windows NT only: Reboot your computer before continuing.

5. Insert the CD labeled “Software Disc 1” into your new CD-Writer Plus

drive and proceed with step 2 in the next procedure.

NOTE: For information about inserting a CD into the CD-Writer Plus drive,
see “Inserting a CD” on page 2-1.