Hitachi 3300MFP 用户手册
194 16 Troubleshooting network problems
EN
Is one of the link lights ON (solid green)?
Check the link lights on your print server; these lights are built into the network connector. One of
the link lights, either the 10 light or the 100 light, but not both, should be ON solid green, to indicate
a valid network connection.
the link lights, either the 10 light or the 100 light, but not both, should be ON solid green, to indicate
a valid network connection.
Link lights OFF
Try the steps below and make any necessary corrections.
●
Make sure that the network cable is connected securely to the print server.
●
Check that the network cable is plugged securely into the hub/switch/router, and that the
connection is set to the correct network speed. (If your hub/switch/router is set to configure its
link speed automatically, try to configure it manually for 10 Mbps or 100 Mbps only. After
changing this setting, you may need to cycle power to the print server—unplug the print
server’s power cable and then plug it in again.)
connection is set to the correct network speed. (If your hub/switch/router is set to configure its
link speed automatically, try to configure it manually for 10 Mbps or 100 Mbps only. After
changing this setting, you may need to cycle power to the print server—unplug the print
server’s power cable and then plug it in again.)
●
Check that the LINK light is ON for the port on the hub/switch/router to which the print server is
connected.
connected.
●
Your network cable may be faulty. Try a different cable.
●
If the light still does not come on, try a different port on the hub/switch/router.
Did these steps turn ON one of the link lights?
If yes, continue with
.
If no, your print server has a problem that requires assistance from HP Jetdirect technical support;
see the support flyer that came with your product for a list of technical support telephone numbers.
see the support flyer that came with your product for a list of technical support telephone numbers.
Check the print server’s I/O status
Check the I/O status of the print server by following these steps:
●
Print a Jetdirect configuration page. To print the page, press the test button on the print server.
●
for help in
getting it to print.
●
On the configuration page, check that the print server reports its status as “I/O Card Ready.”
The Status entry is the first entry in the General Information section, in the upper left portion of
the page. See
The Status entry is the first entry in the General Information section, in the upper left portion of
the page. See
for more details on the configuration page.
If your configuration page shows a status of “I/O Card Not Ready,” continue with
.
Can you print a Jetdirect configuration page?
To print a configuration page, press the test button on the print server.
A configuration page should print on the connected printer. This page displays information about
the print server hardware, the firmware version, the hardware (MAC) address, the connected
printer, network connectivity, network traffic, and network protocols. See
the print server hardware, the firmware version, the hardware (MAC) address, the connected
printer, network connectivity, network traffic, and network protocols. See
for details on the configuration page contents.
.
Configuration page prints?
The Jetdirect configuration page is a page that the print server sends to the attached printer, both
as a test of the connection between the print server and the printer, and as a display of the status
of the print server’s functions. See
as a test of the connection between the print server and the printer, and as a display of the status
of the print server’s functions. See
for details on the
configuration page contents.