Gizzmo Electronics FREEDOM SW112-DVB 用户手册
5
temperature setting guide
label marking
temperature setting
j cool – nylon, acrylics, polyester
1-2
k warm – wool, polyester mixtures
3-4
l hot – cotton, linen
5
i do not iron
, If the instructions on the fabric label differ from this guide, follow
the instructions on the label.
reducing temperature
15 Reducing the temperature takes a bit longer, as the element has
to lose the heat it has built up, so be patient. It’s best to organise
your ironing so that you don’t need to reduce the temperature.
your ironing so that you don’t need to reduce the temperature.
dry ironing
16 If you want to dry iron, empty the reservoir first, to avoid
spontaneous bursts of steam:
a) Unplug the iron, and let it cool down.
b) Hold it over a sink or basin.
c) Flip the water inlet cover open.
d) Carefully, turn the iron upside down.
e) Wipe any spillage off the iron before use.
d) Carefully, turn the iron upside down.
e) Wipe any spillage off the iron before use.
17 Plug it in, and set the temperature.
18 Wait a minute for the iron to heat up.
18 Wait a minute for the iron to heat up.
creasing
19 Squeeze the trigger, to open the soleplate.
20 Slide the garment edge into the gap.
21 Count to 5, then release the trigger.
22 Check the crease, and repeat as necessary,
23 Don’t exceed the 5-count, or you might singe the garment.
21 Count to 5, then release the trigger.
22 Check the crease, and repeat as necessary,
23 Don’t exceed the 5-count, or you might singe the garment.
shot of steam
24 Don’t use the shot of steam function at settings below
S on the thermostat, you’ll get water, not steam.
25 Check that there’s water in the reservoir.
26 Lift the iron off the fabric, and press the steam button.
27 Leave 4 seconds between shots, to let the temperature build up.
26 Lift the iron off the fabric, and press the steam button.
27 Leave 4 seconds between shots, to let the temperature build up.