Gerber Tools Saw 600 用户手册

3 – 7

■ Setting TOOL (cutter blade or pen)

Set the type of pen (cutter blade) to be used.

To display the cutter-pen conditions, either press the 

 (COND.) key when the cutting plotter is in READY

mode, or when the media set lever is lowered and the buffer is in the empty (cleared) status.

Select the setting area (condition number) to be set, and then press the  

 or  

key to move the   sym-

bol to the position shown below.

Press the 

 or 

 key to select “09U,” “15U,” “15B,” or “PEN.” Press the 

 (ENTER) key to confirm

the selection. If other conditions are to be set, press the 

 or  

key to move the   symbol to the param-

eter to be set.

■ Setting OFFSET

This setting adjusts the offset of the cutter blade to suit the blade type used. The tip of the blade mounted

in the cutter-pen plunger is not positioned at the center of the pen, so correction is required. This correction

is referred to as the OFFSET setting. The cutting plotter has been preset with OFFSET values for each cut-

ter-blade type. Selecting “09U,” “15U,” or “15B” for the PEN TYPE setting also sets the appropriate OFF-

SET, allowing fine adjustment within the range of ±5. When the “PEN” setting is selected, the OFFSET

cannot be set.

Press the 

 (COND.) key in READY mode to display the cutter-pen conditions.

Select the setting area (condition number) to be set,  and then use the  

 or  

key to move the   sym-

bol to the position shown below.

Use the 

 or 

 key to select the value to be changed in the range of “-5” to “+5.” Press the 

(ENTER) key to confirm the selection. If other conditions are to be set, press the 

 or  

key to move

the   symbol to the parameter to be set.