Gerber Tools Saw 600 用户手册

4 – 37

■ Setting the STEP SIZE

If the GP-GL command mode is set, the minimum unit of distance that the pen can travel can be changed

to one of four settings: 0.01 mm, 0.025 mm, 0.05 mm, or 0.1 mm. The default setting is 0.1 mm, so change

this setting if your application specifies a different step size.

Set the command setting to “GP-GL.”

Press the 

 (ENTER) key to display the step-size setting menu.

Press the 

 or  

key to select “0.100 mm,” “0.050 mm,” “0.025 mm,” or “0.010 mm,” and then press

the  

(ENTER) key to confirm. To cancel the selection, press the 

 (NEXT) or 

 (PREV.) key.

Press the 

 (PAUSE) key to cancel PAUSE mode.

■ Setting the ORIGIN POINT

If the HP-GL command mode is set, the origin point can be set to the lower left or center. The default set-

ting is the lower left, so change this setting if your application specifies a different origin position.

Set the command setting to “HP-GL.”

Press the 

 (ENTER) key to display the origin-point setting.

Press the 

 or  

key to select “L.L. (LOWER LEFT)” or “CENTER,” and then press the 

 (ENTER)

key to confirm. To cancel the selection, press the 

 (NEXT) or 

 (PREV.) key.

Press the 

 (PAUSE) key to cancel PAUSE mode.