Gerber Tools Saw 600 用户手册

4 – 40

■ Setting Wear-Rate Factors

This sets factors corresponding to the differences in wear rates due to different materials and cutting con-

ditions.

Press the 

 (PAUSE) key to switch to PAUSE mode.

Press the 

 (NEXT) or 

 (PREV.) key until the following menu is displayed.

Press the 

 (ENTER) key to display the wear-rate setting submenu, and then press the 

 (NEXT) or

 (PREV.) key until the following menu is displayed.

Press the 

 (ENTER) key to display the wear-rate factor setting.

Use the 

  or  

key to increase or decrease the setting-area number, and use the 

  or  

key to

increase or decrease the factor value. The factor can be set to between 0.10 and 1.00 in 0.10 intervals, and

between 1.00 and 2.50 in 0.25 intervals. Once the wear-rate factor is set, press the 

 (ENTER) key to

confirm. To cancel the selection(s), press the 

 (NEXT) or 

 (PREV.) key.

Press the 

 (PAUSE) key to cancel PAUSE mode.

■ Clearing the Total Distance (Wear Rate)

Always zero the total-distance display when a cutter blade has been replaced. This starts the total-distance

calculation from zero.

Press the 

 (PAUSE) key to switch to PAUSE mode.

Press the 

 (NEXT) or 

 (PREV.) key until the following menu is displayed.