Exabyte MAGNUM 1X7 LTO 用户手册
102
P
RODUCT
M
ANUAL
1012581
C
HAPTER
7—M
AINTENANCE
C
REATING
A
D
IAGNOSTIC
L
ISTING
VIA
FTP
To create a diagnostic listing via FTP:
1.
1.
1.
1.
Connect to the autoloader’s FTP interface by following the instructions on
.
2.
2.
2.
2.
Make sure that the FTP file transfer type is set to binary.
3.
3.
3.
3.
Use the FTP command for your utility to get the diagnostic listing. For
example, issue a ”get libdump.bin” command.
4.
4.
4.
4.
If necessary, specify a destination location (path and filename) for the
diagnostic listing.
L
IB
T
OOL
—A
UTOLOADER
F
IRMWARE
U
PGRADE
AND
D
IAGNOSTICS
You can also use the Exabyte LibTool to upgrade firmware and create
diagnostic listings over the SCSI interface. Both LibTool and firmware files are
available at
. Refer to the readme file provided
with the program for installation instructions. Refer to the program’s online
help for instructions on performing upgrades and diagnostics.
LTOT
OOL
—T
APE
D
RIVE
F
IRMWARE
U
PGRADE
AND
D
IAGNOSTICS
To upgrade firmware and create diagnostic listings for the LTO tape drive,
. LTOTool allows you
to upgrade firmware and perform diagnostics over the autoloader’s SCSI bus.
Refer to the readme file provided with the program for installation
instructions. Refer to the program’s online help for instructions on performing
upgrades and diagnostics.
Caution
Do not upgrade firmware unless Exabyte Technical Support has advised you to do
so. If performed improperly, the upgrade procedure can render your tape drive
inoperable. Consult with Exabyte Technical Support before performing an
upgrade.