Exabyte MAGNUM 1X7 LTO 用户手册
O
CTOBER
2006
M
AGNUM
1
X
7 LTO A
UTOLOADER
15
C
ONNECTING
THE
A
UTOLOADER
TO
SCSI
3.
3.
3.
3.
From the back of the rack, attach the autoloader to the rails by inserting an
M3 screw into each of the small flanges (see
). Tighten the screws
using a #1 Phillips screwdriver.
C
ONNECTING
THE
A
UTOLOADER
TO
SCSI
This section provides guidelines for connecting the autoloader to a host
system via SCSI. The autoloader includes two SCSI devices: the autoloader
itself and the tape drive. The two devices share one set of wide, low-voltage
differential (LVD) SCSI connectors for connection to a SCSI bus. Up to
16 devices can be connected to a wide LVD SCSI bus.
G
UIDELINES
FOR
C
ONNECTING
TO
SCSI
Keep these guidelines in mind as you plan your SCSI connections:
Do not connect to an inadequate host bus adapter.
Figure 2-7 Attaching the autoloader to the rails at the back of the rack
Insert screw here
!
! !
!
Important
Both LTO-2 and LTO-3 SCSI tape drives are Ultra 160 SCSI
devices and require a minimum Ultra 160 non-RAID SCSI host
bus adapter card, Ultra 160 rated SCSI cabling, and an Ultra 3
Active SCSI terminator.
Caution
Do not connect the autoloader to a high-voltage differential (HVD) SCSI bus.
Doing so may damage the autoloader, tape drive, or other devices on the bus.
!
! !
!
Important
Both LTO-2 and LTO-3 SCSI tape drives are Ultra 160 SCSI
devices and require a minimum Ultra 160 non-RAID SCSI host
bus adapter card.