Gallien-Krueger NEO SERIES NEO 1001/212 用户手册

下载
页码 12
7
Neo Series Bass Combo Amplifi er
Rear Panel Features
20) Woofer  Hi-Cut:    Cuts frequencies above 5kHz 
from the Woofer output.
21) Effects Send:    When used, the signal path is 
in-series, meaning all of the signal goes through the 
Effects Loop.
22) Effects Return:    Returns the Effects Loop signal 
to the signal path.  May also be used as a secondary 
input for another instrument or CD player.  The preamp 
signal is not interupted if the Send jack is not used.
23) Tuner Out:    Parallel output comes directly off 
of the input stage.  Unaffected by the Mute button or 
any of the preamp functions.
24) Power/Protect LED:    The LED will be red for 
5 seconds during power-up, then turns blue when the 
amp is ready.  Should a fault occur, the amp will mute 
and the LED will turn red until the fault is corrected.
23) Power On/Off Button:    If you’re not sure what 
this  does,  you  should  probably  not  be  operating 
electronic equipment.
Rear Panel Features
1) AC Receptacle:     Standard IEC Receptacle.  The 
power cord plugs in here.
2) 700W or 480W Amp Only:    ¼” speaker output 
jacks.  Impedances Lower than 4 Ohms should not be 
used.  Higher impedances such as 8 Ohms, 16 Ohms, 
or No Load are acceptable.  One 4 Ohm, one 8 Ohm,  
or two 8 Ohm cabinets are okay.  One 4 Ohm and one 
8 Ohm together is not recommended.  The internal 
speakers equal  an  8  Ohm  load.    No  damage  will 
result from operating the amplifi er with the speakers 
disconnected.
3) Speakon Outputs:    High current twist-lock Speakon 
output connectors.  Pins 1+ and 1- send a fullrange 
signal from the Main (Woofer) amplifi er.  Pins 2+ and 
2- send a signal 5kHz and above from the Tweeter 
amplifi er.  Use a four-conductor Speakon cable when 
connected to a GK Horn Bi-Amp compatible speaker 
cabinet.  Use a standard two-conductor Speakon cable 
when connected to a non-GK cabinet or if you’re using 
a Speakon to ¼” adapter. See Horn Bi-Amp System 
on page 8 for more information.
Caution:         
Do not connect a Speakon cable labeled “Bridge 
Mode”  to  the  Speakon  Outputs.   This  may 
result in damage to the amplifi er.
3
2
1