Emerson Dual Conversion Online UPS GXT3-6000RT208 用户手册

The final step of installation may require custom configuration of your UPS using the enclosed config-

uration program. Some configuration settings may be changed only while the UPS is off. These should 

be set before the UPS is put into full-time service powering the critical load.
For most users operating with 230VAC and with no external batteries, the factory default settings 

will be adequate. 

• Select L-N output voltages to match local voltages.
• Enable/Disable Auto-Restart.
• Select frequency converter operation with a fixed output frequency of 50 or 60 Hz.
• Set the Low Battery Warning alarm time from 2 to 30 minutes.
• Enable/Disable the Auto-Battery test.
• Set the Auto-Battery test to 7, 14, 21 or 28 days.
• Specify the number of external battery cabinets connected to the UPS to adjust the remaining run 

time calculations reported by Liebert

®

 software products.

• Modify the shutdown setting of the terminal block (for information on pin assignments, see 

Table 2).

In addition to the Liebert GXT3

™

 UPS, you will need the configuration program CD and USB cable 

included in the UPS accessory box. A Windows 95

®

 or later computer, desktop or laptop, is also 

required to set up and run the configuration program.