Electra Accessories 88969 用户手册

STARTING INSTRUCTIONS

First, be sure there is pre-mixed gasoline the gas tank. If unsure about the gasoline mixture, refer

to the Gasoline/Oil Mixing Instructions section. Make sure both fuel lines are properly attached

to the carburetor. There is one main fuel line (black) and one primer bulb line (clear). If these

lines are not properly attached, the engine will not run.

1. Make sure battery is fully charged (see battery charging instructions)

*When using the electric starter feature, the battery on the GAS CHOPPER SCOOTER™ must

be fully charged. To understand how to charge your battery, please see CHARGING THE

GAS CHOPPER SCOOTER™ BATTERY section.

2. Make sure ignition key is in ON position.

3. You will first need to prime the engine with fuel. The primer ball is located on the carburetor,

which is on the front of the engine. (Fig. 1)

4. Pump the primer ball approximately 10 to 15 times, or until fuel is completely visible all

throughout the clear fuel line.

5. Pull the choke lever up, to the "ON" position. (Fig. 2)

Proceed to start the engine using either the Pull Start (Fig. 3)

or the Electric Start (Left brake lever must be engaged with Electric start feature) (Fig. 4)

*If engine does not start with choke Up/On, attempt to start with choke lever on Down/Off position

WHEN USING THE ELECTRIC STARTER FEATURE, THE LEFT BRAKE HANDLE MUST BE ENGAGED!

FAILURE TO ENGAGE THE LEFT BRAKE LEVER WILL NOT ALLOW THE GAS CHOPPER SCOOTER™

TO START USING THE ELECTRICAL STARTER FEATURE!

6. Once the engine starts, allow it to run on its own and warm up for a few minutes. After a few

minutes push choke lever to Down/Off position.

HAVING TROUBLE STARTING YOUR GAS CHOPPER SCOOTER™ ? See our trouble shooting tips
in this manual or call our Techline: 1-888-467-1234 M-F 10am - 9pm EST.

Choke Lever

Up/On

Down/Off

Fig. 2

Fig. 3

Pull Start

Fig. 1

Primer Ball

Fig. 4

Electric Starter Button