Electra Accessories 88969 用户手册

1.  Make sure key is not in ignition

2. Locate Spark Plug (Fig. 1)

3. Remove Spark Plug connector. Gently twist and pull off (Fig. 2)

4. Loosen  Spark Plug with deep socket wrench then unscrew by hand (Fig. 3)

1. Make sure there is no oil build up or residue( If there is, spark plug must be replaced) (Fig. 4)

2. Make sure spark plug has proper spark plug gap of (.6mm - .7mm) 
3. A spark plug gap measuring tool is needed to ensure proper spark plug gap (Fig. 5)

*Refer to Pre-Ride Adjustments in this manual (pg. 14)

*Refer to battery charging instructions (pg. 15)

When maintained and used properly, (by following charging and storage guidelines), the Lead Acid Battery used in this 

product has a normal life span of many miles. When the battery no longer holds a charge or is unable to be charged 

properly, it should be removed from the GAS CHOPPER SCOOTER™ and delivered to a recycling facility. State Laws prohibit 

disposal of lead-acid batteries in everyday trash. Please contact your local solid waste or recycling authority for recycling 

information in your area.

 

 

1. In order to check if there is transmission fluid

     it must be drained.  

2. Remove Fill Bolt(Fig.1)
3. Place Funnel with tube at Drain Bolt. 

4. Remove  Drain Bolt.

5. Drain oil into a clean container or pan 

6. Re-Insert Drain Bolt and tighten

7. Fill Transimission Box  with 70-80 Weight Gear Oil 

    until fluid fills just  below the Transmission Box Oil 

    Fill Bolt.

19