CTC Store IPDSLAM-A8/A16 用户手册

 
 

                                                                 

 

14 

•  The ADSL IP DSLAM can be installed in a standard 19-inch rack, by using 

the mounting brackets provided. 

•  Mount the shelf on the rack using the large screws provided. 

•  Follows the following procedures to connect and wire the system.     

The following is the safety instructions for ADSL IP DSLAM before installation: 

1. Read and follows all warning notices and instructions of this user manual. 

2. The maximum recommended operating temperature for the ADSL IP 

DSLAM is 50ºC. Care must be taken to allow sufficient air circulation or space 
between units when the ADSL IP DSLAM is installed inside a closed rack 
assembly and racks should safely support the combined weight of all ADSL IP 
DSLAM. 

3. The connections and equipment that supply power to the ADSL IP DSLAM 

should be capable of operating safely with the maximum power requirements 
of the ADSL IP DSLAM. In the event of a power overload, the supply circuits 
and supply wiring should not become hazardous.   

4. The AC adapter must plug in to the right supply voltage. Make sure that the 

supplied AC voltage is correct and stable. If the input AC voltage is over 10% 
lower than the standard may cause the ADSL IP DSLAM to malfunction. 

5. Do not allow anything to rest on the power cord of the AC adapter, and do 

not locate the product where anyone can walk on the power cord. 

6. Generally, when installed after the final configuration, the product must 

comply with the applicable safety standards and regulatory requirements of the 
country in which it is installed. If necessary, consult for technical support. 

7. A rare condition can create a voltage potential between the earth grounds of 

two or more buildings. If products installed in separate building are 
interconnected, the voltage potential can cause a hazardous condition. 
Consult a qualified electrical consultant to determine whether or not this 
phenomenon exists and, if necessary, implement corrective action before 
interconnecting the products. If the equipment is to be used with 
telecommunications circuit, take the following precautions: