Country Home Products Men's Trimmer 用户手册

下载
页码 44
DR
®
 TRIMMER/MOWER
 Safety & Operating Instructions 
13
 
Chapter 4: Operating Your DR
Chapter 4: Operating Your DR
 TRIMMER/MOWER
 TRIMMER/MOWER
  
This chapter covers the procedures for starting and stopping your new DR
 TRIMMER/ 
MOWER
 and discusses basic operation features. You may find it helpful to review the DR
 
TRIMMER/MOWER
 Controls and Features picture (Figure 1) on page 8 before reading this 
chapter. 
Electric-Starting 
Note: Use the following steps with electric-starting models only. 
1. Push the throttle lever on the right side of the handlebar (see trimmer picture, Figure 
1, on page 8) all the way forward to the START position. 
2. If your model has a primer, prime the engine. 
 Push the primer bulb in (see trimmer picture, Figure 1, on page 8) for three seconds and 
completely release it, letting it pop back to its original position. Repeat three to four 
times. 
Note: Priming is usually not necessary when restarting a warm engine. In cool weather, 
you may need to repeat priming. 
3. Turn the key (see trimmer picture, Figure 1, on page 8) to the START position until 
the engine starts, then release. The key will snap back to the RUN position and the 
engine will continue to run. 
Manual-Starting 
Note: You may use this starting method with both manual and electric-starting models. 
1. Push the throttle lever on the right side of the handlebar (see trimmer picture on page 8) 
all the way forward to the START position. 
2. If your model has a primer, prime the engine. 
 Push the primer bulb in (see trimmer picture on page 8) for three seconds and 
completely release it, letting it pop back to its original position. Repeat three to four 
times. 
Note: Priming is usually not necessary when restarting a warm engine. In cool weather, 
you may need to repeat priming. 
3. Grasp the recoil starter handle and slowly pull until you feel resistance. Let the cord 
retract a little bit, then pull the cord rapidly to start the engine. One or two pulls 
usually starts the DR
 TRIMMER/MOWER
It may be necessary to repeat priming if 
the machine does not start within two pulls.