Country Home Products Men's Trimmer 用户手册
26
DR
®
TRIMMER/MOWER
™
Safety & Operating Instructions
Figure 19
Figure 20
Removing and Reinstalling the Mow-Ball
Support
Assembly
Tools needed: You will need a #3 Phillips head screwdriver with at least a 6
″
shank. or the
head locking tool that comes with your trimmer.
1. Insert the screwdriver or
head locking tool into the
hole in the frame, then
rotate the Mow-Ball
hole in the frame, then
rotate the Mow-Ball
Support until the
screwdriver fits into a
second hole in the shaft,
locking it into place
(Figure 19).
screwdriver fits into a
second hole in the shaft,
locking it into place
(Figure 19).
2. Turn the Mow-Ball
Support assembly
counterclockwise until it
unscrews completely from
the bearing housing.
(Figure 20). Remove the
tool or screwdriver after
you’ve removed the Mow-
Ball
counterclockwise until it
unscrews completely from
the bearing housing.
(Figure 20). Remove the
tool or screwdriver after
you’ve removed the Mow-
Ball
assembly.
Note: If the Mow-Ball
Support assembly
continues to turn, but does
not come off, check to be
sure the screwdriver is
locked into the shaft.
continues to turn, but does
not come off, check to be
sure the screwdriver is
locked into the shaft.
3. To reinstall the Mow-Ball
Support assembly, reverse
the above instructions.
the above instructions.
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.