Country Home Products Men's Trimmer 用户手册

 

 

 

Removing and Replacing the Belt 

 
 
 
 
 
 
Tools needed: You will need the tools listed below. 

■ 

9

⁄

16

″

 wrench or socket 

■ 

3

⁄

16

″

 Allen wrench 

■ 

DR



 

belt (Part Number – 114431) 

1. Remove the Mow-Ball



 Support assembly. (See “Removing and Reinstalling the Mow-Ball



 

Assembly” on page 26.) 

2. Remove the stone guard flap. 

(See “Removing the Stone Guard 
Flap” on page 28.) 

3. Remove the bottom shield. (See 

“Removing the Bottom Shield” 
on page 28.) 

4. Remove the four Allen set bolts 

on the underside of the lower 
bearing housing plate (Figure 
25). The lower bearing should 
come off with the plate (Figure 
26). 

5. Remove the belt. 
6. Install the new belt. Be sure the 

belt is on the inside of idler 
pulley 2, the outside of idler 
pulley 1 and correctly fitted 
around the engine pulley (Figure 
24). 

7. Replace the lower bearing 

housing plate, being sure to align 
the notch with the locking tool 
hole in the side of the housing 
and mount the four set screws in 
this order: Mount and make snug 
one set screw, then the set screw 
opposite it. Make the other two 
screws snug. 

8. Tighten all four in the same 

pattern. Do not over tighten the 
set screws 

9. Reinstall the bottom shield. 
10. Reinstall the stone guard flap. 
11. Reinstall the Mow-Ball



 Support 

Assembly. 

 

