Contax U4R 用户手册
EN-189
The picture
came out
completely
white.
came out
completely
white.
The image is overexposed.
Set the exposure compensation
to a negative value, or execute
mode reset.
to a negative value, or execute
mode reset.
There is a lot of
'noise' in the
image.
'noise' in the
image.
Noise is more likely to occur
if high ISO settings are used.
if high ISO settings are used.
Use the flash or reduce the ISO
sensitivity before shooting.
sensitivity before shooting.
The SD memory card is
write-protected.
write-protected.
Remove the write-protection for
the card.
the card.
When I connect
the camera to
my computer, no
[Removable
disk], [untitled]
or [NO_NAME]
icon appears.
the camera to
my computer, no
[Removable
disk], [untitled]
or [NO_NAME]
icon appears.
The USB cable is not
connected properly.
connected properly.
Make sure that the USB cable is
securely connected.
securely connected.
The USB cable is connected
to the keyboard or to the
USB port on a USB hub.
to the keyboard or to the
USB port on a USB hub.
Plug the USB cable into the USB
port on the PC.
port on the PC.
-
The drivers are not installed,
or installation failed.
or installation failed.
Follow the procedure described
in Deleting the Device (Windows
98 and Windows 98SE only).
in Deleting the Device (Windows
98 and Windows 98SE only).
I cannot connect
to the printer.
to the printer.
The printer does not support
PictBridge.
PictBridge.
Refer to the instructions
provided with the printer.
provided with the printer.
-
The printer is not connected
correctly.
correctly.
Check that the camera is
correctly connected to the
printer with the USB cable.
correctly connected to the
printer with the USB cable.
Movies cannot be printed.
-
-
You cannot use DPOF
printing if the printer does not
support DPOF printing.
printing if the printer does not
support DPOF printing.
Refer to the instructions
provided with the printer.
provided with the printer.
-
Problem
Cause
Solution
Page