Contax U4R 用户手册

4

Press the shutter release button down 

fully.

The camera starts shooting the movie.
During movie shooting, the shooting mark (a red "Z") appears and the 
self-timer LED lights. The elapsed shooting time is displayed in the 
upper right of the screen and the focus frame disappears.
When the remaining shooting time drops below approx. 10 seconds, the 
time display turns red.

The table below shows the available shooting times for each image size using a 256 MB memory card.
(Times given are for a new or freshly formatted high speed memory card at a frame rate of 30fps)

Available shooting time display in movie mode
• The shooting time shown on the LCD monitor when you start shooting in movie mode does not indicate 

the time available for one continuous shot. The length of a continuous movie shot is limited by the speed 
at which data is written to the SD memory card and differs depending on the card you are using.

• If you use a high-speed SD memory card (an SD memory card with a write speed of 10 MB/sec or 

faster), the available shooting time displayed on the LCD monitor serves as a guide to the actual 
continuous shooting time available.

5

Press the shutter release button half way to stop shooting.

Image Size

Time

640 x 480

Approx. 1 min. 
50 sec.

320 x 240

Approx. 7 min.

A

Important

Depending on the SD memory card write speed, the camera may stop shooting mid-
shot.

B

Note

If you do not press the shutter release button half way, shooting continues until the 
memory card is full.

00:18

00:18