Freud Tools FJ85 用户手册

a) Secure your work.  Use clamps or a vise to secure and support the work piece to a stable 

platform.  Securing the work with a clamp or vise frees both hands to operate the tool.  
Holding the work by hand or against your body is unstable and may lead to loss of control.

b) Do not force tool.  The power tool will do the job better and safer at the rate for which it was 

intended.

c) Use the correct tool for your application.  Do not use tools for purposes for which they were 

not intended.

d) Do not use tool if switch does not turn it on or off.  Any tool that cannot be controlled with 

the switch is dangerous and must be repaired.  Have defective switches replaced by an 
authorized Freud service center.  

e) Disconnect the plug from the power source when not in use, before servicing, and when 

changing accessories such as blades, bits, and cutters.  Such preventive safety measures 
reduce the risk of starting the tool accidentally and causing personal injury.

f) Store idle tools when not in use.  Tools should be stored in a dry, high, or locked-up place 

and out of the reach of children.

g) Maintain tools with care.  Keep cutting tools sharp and clean for better and safer 

performance.  Follow instructions for lubricating and changing accessories.  Inspect tool 
cords periodically and, if damaged, have repaired by an authorized Freud service center.  
Inspect extension cords regularly and replace if damaged.  Keep handles dry, clean, and 
free from oil or grease.  Properly maintained tools, with sharp cutting edges are less likely to
bind and are easier to control.

h) Check for damaged parts.  Before further use of the tool, a guard or other part that is 

damaged should be carefully inspected to determine that it will operate properly and perform
its  intended function.  Check for alignment of moving parts, binding of moving parts, 
mounting, and other conditions that may affect the operation of the tool.  A guard or other 
part that is damaged should be properly repaired or replaced by an authorized Freud service
center unless otherwise indicated elsewhere in this instruction manual.  

i) Use only accessories that are recommended by the manufacturer for your model.  

Accessories that may be suitable for one tool may become hazardous when used with 
another tool.

a) Tool service must be performed only by a Freud authorized service center.  Service or 

maintenance performed by unqualified personnel could result in a risk of injury.  

b) When servicing a tool, use only identical replacement parts.  Follow instructions in the 

Maintenance section of this manual.  Use of unauthorized parts or failure to follow 
maintenance instructions may create a risk of electric shock or injury.  Certain cleaning 
agents such as gasoline, carbon tetrachloride, ammonia, etc. may damage plastic parts.

1. Hold tool by insulated gripping surfaces.  Contact with a “live” wire will make exposed metal 

parts of the tool “live” and shock the operator.

2. Never perform an operation where the cutting tool may contact hidden wiring or its own cord 

such as cutting into a wall that might contain electrical wiring.

3. Keep hands away from the cutting area.  Do not reach under the material being cut.  The 

proximity of the blade to your hand is hidden from your sight.

4. Keep hands from between the gear housing and saw blade holder.  The reciprocating blade 

holder can pinch your fingers.

5. Use only sharpened saw blades in perfect condition and immediately change the blade if 

deformed or notched.  Bent blades can break easily or cause kickback.