Fire Sense PH03-S 用户手册
In a salt-air environment (such as
near an ocean) corrosion occurs
more
near an ocean) corrosion occurs
more
quickly
than
normal.
Frequently check for corroded areas
and repair them promptly.
and repair them promptly.
WARNING
FOR YOUR SAFETY:
DO NOT touch or move heater for at
least 45 minutes after use.
Allow all burner elements to cool
before touching.
FOR YOUR SAFETY:
DO NOT touch or move heater for at
least 45 minutes after use.
Allow all burner elements to cool
before touching.
Check your hose assembly:
persons and be in accordance with the relevant codes of practice.
Warning: This appliance requires a ga
Warning: This appliance requires a ga
necessary, replace the gas hose.
factory suggested replacement.
Check Your Flame:
The flame pattern at the emitter screen should be visually checked
whenever heater is operated.
Normally the burner flame is blue, but a little yellow flame is acceptable.
If flames extend beyond the emitter grid or there are black spots that have
accumulated on the emitter grid or reflector, immediately turn off the patio
heater. The heater should not be operated again until it has been serviced
and repaired by a qualified gas technician.
The flame pattern at the emitter screen should be visually checked
whenever heater is operated.
Normally the burner flame is blue, but a little yellow flame is acceptable.
If flames extend beyond the emitter grid or there are black spots that have
accumulated on the emitter grid or reflector, immediately turn off the patio
heater. The heater should not be operated again until it has been serviced
and repaired by a qualified gas technician.
Cleaning Your Heater:
To enjoy years of outstanding performance from your heater, make sure
you perform the following maintenance activities a on regular basis:
1. Keep exterior surfaces clean
To enjoy years of outstanding performance from your heater, make sure
you perform the following maintenance activities a on regular basis:
1. Keep exterior surfaces clean
● Use warm soapy water for cleaning. Never use flammable or corrosive
cleaning agents.
● While washing your unit, be sure to keep the area around the burner
and pilot assembly dry at all times. If the gas control is exposed to water
in any way, do not try to use it. It must be replaced.
in any way, do not try to use it. It must be replaced.
2. Air flow must be unobstructed. Keep controls, burner, and circulating
air passageways clean. Signs of possible blockage include:
● Gas odor with extreme yellow tipping of flame
● Heater does not reach the desired temperature
● Heater glow is excessively uneven
● Heater makes popping noises
● Heater does not reach the desired temperature
● Heater glow is excessively uneven
● Heater makes popping noises
3. Spiders and insects can nest in burner or orifices. This dangerous
condition can damage heater and render it unsafe for use. Clean
burner holes by using a heavy-duty pipe cleaner. Compressed air
may help clear away smaller particles.
burner holes by using a heavy-duty pipe cleaner. Compressed air
may help clear away smaller particles.
4. Carbon deposits may create a fire hazard. Clean dome and emitter
screen with warm soapy water if any carbon deposits develop.
MAINTENANCE / STORAGE
NOTE:
The installation of fixed appliance shall only be carried out by competent
s hose and regulator. Check with your
gas supplier and or product supplier. Regularly check the gas hose and if
Prior to use, check for damaged parts such as hoses, regulator, pilot or burner.
Never replace or substitute the regulator with any regulator other than the
Never replace or substitute the regulator with any regulator other than the