Cable Electronics CELABS HSW88C 用户手册

DIP SWITCH

NEC 

 

 

RC5 

 

 

TOSHIBA MICOM 
CODE 

 

 

GRUNDIG CODE 

 

 

SONY 12 BIT CODE 

 

 

SONY 15 BIT CODE 

 

 

SONY 20 BIT CODE 

 

 

RCA CODE 

 

 

RCM CODE 

 

 

MATSUSHITA CODE 

 

 

MITSUBISHI CODE 

 

 

ZENITH CODE 

 

 

JVC CODE 

 

 

M50560-001P 

 

 

MN6125H 

 

 

MN6125L 

 

 

MN6014_C5D7 

 

 

MN6014-C6D6 

 

 

MC14457P 

 

 

LC7464(AHEA) 

 

 

GEMINI_CM 

 

 

The IR extension cables are standard market configuration. 
You can buy From CE labs if necessary for replacement use.

Note:
1. If the HDTV shows video but without audio, please try to set 
    audio mode to stereo. 
2. Factory default setting of [SW1]-[SW8] is pin#1-OFF[   ] & 

    pin#2- OFF[   ] for 1080p with stereo.

3. If you encounter any unsolved audio/video output problem 
    during system installation, please turn any [SW1]-[SW8] to 
    pin#1-OFF[   ] & pin#2-ON[   ] for safe mode to enforce the 

    most compatible 720p stereo output for system check. 

    However, the safe mode cannot be initiated if your HDMI 
    source is set to enforce 1080p output. In this case, please 
    reconfigure your HDMI source to all resolution output for 
    troubleshooting.

4. Bypass means the matrix will maintain playing the original 
    format of HDMI signals in video and perhaps audio. By 
    setting at this mode, the users may encounter compatibility 
    issue among different kinds of HDMI sources and displays. If 
    you cannot get the audio and/or video output normally at 
    the system installation, please change the DIP switch setting 
    to default mode or even safe mode to verify the 
    functionality of the device.
5. To learn the EDID of HDMI display for respective HDMI source 
    devices, please see the [EDID Learning] section in the next 
    page for more detail information.

OFF [ ]  OFF [ ] 

Up to 

1080p 

Stereo

1

 

2

 – Up to 1080p & stereo audio output for 

most HDTVs 

OFF [ ] 

ON [ ] 

Up to 

720p / 

1080i 

Stereo 

3

 – Enforce the system output at 720p/1080i 

video and stereo audio for basic compatibility among 
HDTVs 

ON [ ] 

OFF [ ] 

Bypass

4 

Bypass

 

 – for learning EDID from the 

display while playing any received HDMI audio format 

ON [ ] 

ON [ ] 

Bypass 

Stereo 

 – for learning EDID from 

the display while enforcing stereo output if any HDTV 
cannot play surround sound normally