Avaya Media Gateway G700 用户手册

Events occurring on the G700 cause SNMP traps to be generated. The G700 MGP can be 
configured to send SNMP traps to any network management system (NMS) in the network, 
including the primary server (S8300, S8400, S8500, or S8700-series Media Server). The MGP 
CLI set snmp trap command is the way to configure the NMS network element that will 
receive those traps. 

The command syntax is:

where 

 is the IP address of the NMS trap receiver that will be receiving the traps 

from the G700, and

 indicates the 

groups whose traps will be sent to the specified receiver. If no keywords follow the IP 
address entry, then ’all’ traps will be enabled for the specified receiver.

If ’enable’ or ’disable’ is used without a trap designation keyword, then ’all’ traps is 
assumed. Up to ten trap receivers can be configured.

1. At the P330-1(super)# prompt, type session mgp 

2. At the mg-xxx-n(super-user)# prompt, type configure and press Enter.

3. At the mg-xxx-n(configure)# prompt, type 

 

and press Enter.

4. Type exit