Avaya Media Gateway G700 用户手册

1. At the MG-???-n(configure)# prompt, type

to specify the gateway to handle addresses outside of the local subnet. 

 is the IP address of the default network gateway. This address 

should be available in the planning documentation.

2. Type show ip route mgp to view the results.

3. Repeat Step 1 for additional ip routes, if needed. 

Usually, only a default route is needed. Refer to your planning document.

From the G700 media gateway processor command line interface, you assign IP addresses to 
the VoIP resource resident on the G700 media gateway and to any installed MM760 VoIP media 
modules.

1. At the MG-???-n(configure)# prompt, type set interface voip <number> <ip 

 is the slot number of the VoIP media module. v0 designates the VoIP resource 

resident on the G700 Media Gateway motherboard. The MM760 VoIP Media Modules are 
designated according the slot (for example, v1, v2, v3, v4) in which the media module has 
been installed. 

 is the IP address of the VoIP resource.

For example: set interface voip v0 132.236.73.3 

2. Type show interface to display a table of all configured interfaces, including all VoIP 

Media Modules. 

3. Type show voip v0 to display the VoIP resource on the motherboard.

Note:

It is not necessary to configure the VLAN, netmask, or IP routes for VoIP engines. 
The media gateway parameters are applied automatically.

After you have assigned IP addresses to the P330 Stack Processor (Layer 2 Switching 
Processor), the G700 Media Gateway MGP, media modules, and the VoIP resources, validate 
the IP connections.