Avaya Media Gateway G700 用户手册

6. In the TYPE column, find the particular media module (v1 through v4), then check the 

matching field in the FW VINTAGE column to see if it matches the planning documentation. 

Note:

Slot V1 can contain either a media module or the S8300, which will show as 
TYPE ICC

.

7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP 

firmware identified in the planning documentation.

8. Type reset <module #> 

where <module #> is the number of the G700 in the stack. 

9. When the reset is finished, type show mm to verify the upgrade.

1. When the upgrade procedure is complete, go to the SAT session and release the board

Type release board vx 

where x is the slot number of the upgraded media module. 

2. Verify the response, 

Command Successfully Completed

Note:

If you see the response, Board Not Inserted, this means that the media 
module is still rebooting. Wait one minute and repeat the release board 
command.

3. Repeat the release board command for each media module that was busied out.

Spanning Tree (STP) is a loop avoidance protocol. If you don't have loops in your network, you 
don't need STP. The "safe" option is always to leave STP enabled. Failure to do so on a network 
with a loop (or a network where someone inadvertently plugs the wrong cable into the wrong 
ports) will lead to a complete cessation of all traffic. Rapid Spanning Tree is a fast-converging 
protocol, faster than the earlier STP, that enables new ports much faster (sub-second) than the 
older protocol. Rapid Spanning Tree works with all Avaya equipment, and can be 
recommended. 

Rapid Spanning Tree is set using the P330 stack processor command line interface.