Avaya Media Gateway G700 用户手册

10. Verify that the download was successful when the prompt returns.

Type show mg list_config. 

The system displays the list of software.

For upgrades of active media modules, you need to take the media modules out of service 
before initiating the upgrade process. To do this, go to a SAT session on the primary controller 
and issue a busyout command.

Note:

Skip this busyout procedure if the media modules are not in service; for example 
during an initial installation.

1. Go to a SAT session on the primary controller and enter the command, 

 

where x is the slot number of the media module to be upgraded.

2. Verify the response, 

Command Successfully Completed

3. Repeat for each media module to be upgraded.

1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on 

the G700 motherboard). 

This VoIP module does not occupy a physical position like other media modules.

2. At the P330-1(configure)# prompt, type session mgp.

3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.

SLOT  TYPE 

CODE

 SUFFIX  HW VINTAGE  FW VINTAGE  VOIP FW

---- ------ 

----- ------ ---------- ---------- -------

V0  G700 DAF1 A 

00 

230(A) 

67

V1 ICC S8300 

A 

72 

00 

N/A

V2 DCP MM712 

A 

2 

58 

N/A

V3 ANA MM711 

A 

2 

57 

N/A

V4 DS1 MM710 

A 

1 

58 

N/A