Autodesk XW8400 用户手册

Introduction

1

10

   

System ROM Flash was successful appears.

Verify system BIOS settings. See 

From the File menu, select Save Changes and Exit.

You do not normally need to adjust BIOS settings on your workstation. BIOS settings for the 
workstation are provided here for informational purposes only. 

To enter the system BIOS, press F10 while booting the workstation.

Before installing Red Hat® Linux, it is recommended that you verify the workstation’s 

BIOS settings. If the storage SATA emulation option is not set correctly (to Separate IDE Controller), 

you must redo Red Hat Linux installation.

The following table lists the proper Autodesk certified BIOS settings. Items not listed are set to 
their default factory settings.

The following procedure restores the default factory BIOS settings.

Press F10 while booting the workstation to enter the system BIOS.

From the File menu select Default setup | Restore Factory Settings as 
Default

. 

Storage, Storage options

SATA Emulation

Separate IDE 
Controller

Storage

Boot Order

Optical Drive
USB Device
Hard Drive, 
Integrated SATA
Hard Drive, 
Integrated IDE

Storage, Power, OS Power Management

Runtime Power 
Management

Disabled

Storage, Power, OS Power Management

Idle Power Savings

Normal

Storage, Power, OS Power Management

ACPI S3 Support

Disabled

Storage, Advanced, Device Options

S5 Wake on LAN

Disabled

Advanced

Slot5 - PCI 133

Slot5 speed 100Mhz 
PCI-x m1