Atlas COMMANDER 330 用户手册

A short circuit has been detected on the programming track.

Check relevant connections and/or decoder installation in the

locomotive.

No value was found during the readout of a Register, or no

response was received after a value was entered. However, this

does not necessarily mean the decoder did not accept the new

values. Please try using the new address before attempting to

program again. You should also check if the locomotive is on

the right programming track and/or the installation of the

decoder.

System Settings
The following system parameters can be edited or viewed:
• Version number of the Commander software (view only).
• Service number of the Commander. You will be asked to identify this

number if you call in for assistance with your Commander.

• If your Commander is set to function as a master or as a slave (also called

an XpressNET unit).

1. Press both     and     buttons at the same time to access the Menu system.

Use the "+" or "-" buttons to scroll to the System menu. 

Press Enter to select the System mode setting.

The first system setting (shown to left) is the Commander

software version number setting option. 

Press Enter to view the version number. You cannot

change this value; it is read-only. Press Exit to go back to

System menu.

Press +/- buttons until you see the service number system

setting option (shown on left).

Press Enter to view the service number. You cannot

change this value; it is read-only. Press Exit to go back to the

System menu.

Press "+" or "-" button until you see the Master/Slave system

setting (shown on left). Press Enter to select setting options.

Press "+" or "-" button to scroll through the options. To make

your Commander operate in master mode, press Enter when

you see the display on left.

To have your Commander operate in slave mode, press Enter

when you see display on left. Press Exit to leave the menu.

Adding Additional Throttles
If you would like to have more than one operator on your layout, you may
connect up to five additional Commanders or handhelds that conform to
XpressNET standards to your original unit. When you have more than one
Commander, one becomes the "master" and the other(s) become "slaves." The
master provides track power, the slaves do not. Any Commander (master or
slave) that is connected to a Generator may be used for programming. In the
case of a slave that is used for programming, it must be connected to a pro-
gramming track via output terminals P & Q and must be connected to a

EXPANDING YOUR SYSTEM