ArtDio IPE 1000 用户手册

 

 

78

Using the system console to upgrade the firmware is quite similar to using the Web management interface. 

You must run the TFTP server first. You must also assign the IP address of the TFTP server and filename 

separately. After they are configured, issue a copy command to initiate the firmware upgrade. You can also 

combine three commands into one. Following these steps: 

 

Step 1: Configure TFTP server and filename 

a) Separate command:  

 

                 1. PBX Gateway(config)# tftp server <ip-address | domain name> 

 

                 2. PBX Gateway(config)# tftp filename <filename> 

 

                 3. PBX Gateway(config)# exit 

                 4. PBX Gateway# copy tftp:/// 

b)Combined command 

<ip-address>/<filename> 

 

PBX Gateway(config)#copy tftp://192.168.0.201/a:\runtime.tcw 

TFTP Server: 192.168.0.201 

a:\runtime.tcw 

Downloading…. 

 

Step 2: The Gateway should now be downloading the firmware. Wait for the result. 

PBX Gateway(config)#copy tftp://192.168.0.201/a:\runtime.tcw 

TFTP Server: 192.168.0.201 

a:\runtime.tcw 

Downloading.... 

Download success 

System must reload 

 

Step 3: If the gateway downloaded the firmware successfully, issue a cold-start to launch the new code. 

       PBX Gateway(config)#reload