Ariens Ventilation Hood SBXC900SS 用户手册

 

4

(DUCTED HOODS ONLY) 

Caution: To reduce the risk of fire, use metal 

ductwork is preferred. 

1.  Decide where the ductwork will run between 

the hood and the outside. 

2. 

A straight, short duct run will allow the hood to 

perform most efficiently. 

3.  Long duct runs, elbows, and transitions will 

reduce the performance of the hood. Use as few of them as possible. Larger 

ducting may be required for best performance with longer duct runs. 

4.  The air must not be discharge into a flue that is used for exhausting fumes from 

appliances burning gas or other fuels" "Regulations concerning the discharge of air 

have to be fulfilled. 

5.  Install wall cap. Connect round metal ductwork to cap and work back 

towards hood location. Use duct tape to seal the joints between ductwork 

sections. 

 

Electrical wiring must be done by a qualified person(s) in accordance with all applicable 

codes and standards. This range hood must be properly grounded. Turn off electrical 

power at service entrance before wiring. 

 

If the supply cord is damaged, it must be replaced by the manufacturer, its service 

agent or similarly qualified persons in order to avoid a hazard

.

 

 

Note 1 : On stainless steel hoods, carefully remove the plastic protective film from all 

exterior surfaces of the hood and chimney prior to final installation.   

Note 2:    At least two people will be required to mount the hood.