Apex Digital AP-9060 用户手册

 

Page 4 of 18 

Thank you for choosing ApexCCTV.  We hope that this document will assist you in 
configuring your new AP-9060/AP-16CO for use on your network and via the internet.  
This document follows industry standard best practices, and while you do not need to 
follow every single step on this list, doing so will provide you with a reliable and secure 
connection to your AP-9060/AP-16CO. 

This document requires a basic understanding of networking principles including, but not 
limited to, network address translation (NAT), transmission control protocol/internet 
protocol (TCP/IP), user datagram protocol (UDP), subnet and subnet mask configuration, 
dynamic host configuration protocol (DHCP), IP addresses, routing and router 
configuration, public vs. private networks, etc… 
 
The basic knowledge described above is outside the scope of this document, and will be 
covered briefly or not at all, and only as it applies to an individual step you need to take 
in configuring your AP-9060/AP-16CO.  Please find other resources in the “Additional 
Resources” section at the end of this document. 

The gist of setting up your AP-9060/AP-16CO for network use is very straightforward.   
 

1)  Configure your AP-9060/AP-16CO with an appropriate network address (use best 

practices). 

2)  Forward ports 80, 5000, 5001 through one or more routers, starting with your 

internet gateway. 

1)  Your network enabled AP-9060/AP-16CO from ApexCCTV, with working 

cameras connected. 

2)  The CD that came with your AP-9060/AP-16CO. 
3)  Your AP-9060/AP-16CO manual (may be on your CD) 
4)  A Television monitor, hooked up to the DVR. 
5)  A Network cable connecting your DVR to your network. 
6)  A router. 
7)  An additional PC on your network with Windows (Preferably XP) installed.