AMX MET-ECOM-D 用户手册

Mounting and Installation

21

 Metreau Entry Communicators 

Wall Surface Installation (Using Expansion Clips)

Expansion clips are mounted through the 2 holes located along the rim of the wall box (see FIG. 18). As 
the screw is tightened, the clip bends toward the insertion hole and into the wall. This bending creates a 
"grip" on the wall by either pressing onto the wall or by securing the drywall between the housing and 
the drywall clip. The most important thing to remember when mounting the wall box is that the outer 
trim must be installed flush against the mounting surface. 

FIG. 18 provides recommended cutout dimensions for the wall box. It is recommended that you cutout 
the surface slightly smaller than what is outlined in the installation drawings so that you can make any 
necessary cutout adjustments. 

If assembled, remove the Metreau Entry Communicator from the wall box.

Cut out the surface for the Wall Box using the dimensions shown in FIG. 18. 

Run the Ethernet cable and an Earth ground wire into the wall box through the provided breakaway 
access points on the wall box. Leave enough slack in the wiring to accommodate any re-positioning 
of the unit.

Recommended Cutout For Wall Box