American Standard ALTO 70145A 11/00 用户手册
AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual
Page 19
Burning or glazing.
Dull abrasive.
Replace abrasive.
Excessive sanding pressure.
Decrease sanding pressure
setting. Fig. #14, page 13.
Too fine of an abrasive.
Use coarser abrasive.
Slow cutting.
Dull abrasive.
Replace abrasive.
Too fine of an abrasive belt.
Use a coarser abrasive belt.
Insufficient sanding pressure.
Increase sanding pressure
setting. Fig. #14, page13.
setting. Fig. #14, page13.
Waves on sanded surface.
Debris on wheel.
Remove and clean wheels.
Flat spot on tire(s).
Replace tires.
Chatter marks on sanded
See Chatter Wave Prevention.
See Chatter Wave Prevention.
surface (close evenly spaced )
Difficult to actuate tension
Debris interferes with mechanism.
Blow out sanding chamber.
release lever.
Remove and disassemble
mechanism. Clean out.
mechanism. Clean out.
Worn sleeve bearing.
Replace.
Galled linkages.
Lubricate with WD-40.
Abrasive belt will not track.
Extreme difference in side-to-side
Replace abrasive belt.
lenght of belt.
High edge on contact wheel.
Check several different abrasive
belts. Contact an authorized
dealer or replace the contact
wheel.
belts. Contact an authorized
dealer or replace the contact
wheel.
Abrasive belt tears along its
Debris built-up on (top) tension roller.
Clean tension roller.
length.
P
ROBLEM
C
AUSE
A
CTION
Troubleshooting
IVIE Enterprises
www.ivie-ent.com
Ph:(918)254-5161 or (888)262-5161 Fax:(918)250-4807