AMANO HandPunch 1000 安装指导
HandPunch 1000 Installation and Operation Manual
Page 32
Revision 1.2
8.5.3
Navigating Command Menus
Once you have entered a command menu, there are three options available for
navigating the command menu system.
navigating the command menu system.
•
Press
to enter the command shown on the display.
•
Press
to step to the next command in the menu.
•
Press
to exit the command menu (pressing any numeric key also exits
the command menu). If you are in a command’s sub-menu, you may have to press
multiple times to completely exit the command menu.
8.6
System Maintenance
Once a HandPunch system is in operation the following commands are used for
system maintenance. These commands are performed through the Service Menu. The
instructions for system maintenance begin on page 35.
system maintenance. These commands are performed through the Service Menu. The
instructions for system maintenance begin on page 35.
Calibrate – View HandPunch calibration values.
Status Display – Display HandPunch Input/Output status.
Status Display – Display HandPunch Input/Output status.
There are NO user servicable parts inside the HandPunch.
8.6.1
Cleaning the HandPunch
Inspect and clean the HandPunch regularly to maintain optimum performance. Clean
the platen, side mirror, reflector, and the window above the platen using a clean cloth
dampened with ordinary, non-abrasive window cleaner (see Figure 8-1). Start at the
rear corners of the platen and work your way forward.
the platen, side mirror, reflector, and the window above the platen using a clean cloth
dampened with ordinary, non-abrasive window cleaner (see Figure 8-1). Start at the
rear corners of the platen and work your way forward.
DO NOT SPRAY CLEANING FLUID DIRECTLY INTO OR ON THE HANDPUNCH.
Figure 8-1: HandPunch Cleaning
#
*
CLEAR
CLEAR
NOTE
NOTE