Alesis MMT-8 用户手册
- Page 31 -
21 TAPE
The TAPE button is used to access the tape interface features of the MMT-8. This allows the user to save
and retrieve sequence data with an ordinary cassette recorder. Pressing and holding the TAPE button
and retrieve sequence data with an ordinary cassette recorder. Pressing and holding the TAPE button
results in the following display:
Pressing the RECORD button initiates the save to tape. Both buttons can now be released, since this
operation may take over two minutes, during which the display will read:
The display shows the current part or song being output. This display will advance until all data is output.
Pressing the STOP/CONTINUE button will abort the operation. Before pressing RECORD, the page up and
page down buttons can be used to access the other five tape pages. They are as follows:
In all five of these pages, pressing RECORD initiates the operation. The verify function is used to ensure
that the data just recorded to tape is good. LOAD ALL PARTS & SONGS FROM TAPE loads the entire
sequence memory with the data on tape. LOAD ONE PART FROM TAPE and LOAD ONE SONG FROM
TAPE allow a single part or song to be loaded from a tape. The keypad can be used to select the desired
TAPE allow a single part or song to be loaded from a tape. The keypad can be used to select the desired
number. For operations involving output to tape, after pressing RECORD the display will change to the
following:
When the initial tone on the tape is detected, the display shows (depending on the page shown when
RECORD was pressed):