Alfa Romeo 147 业主指南

Turning the ignition key to 

MAR the dig-

ital multifunction display shows the writing
“

OIL” for about 10 seconds.

Then, the engine oil level is detected for

some seconds, during which the display
shows six bars. At the end of this operation,
the display will show the oil quantity (

84) and then the information concerning
the partial and total kilometres travelled.

Fig. 84 refers to the correct engine oil

display. As the oil level gradually falls, the
full bars go off.

IMPORTANT To make sure that the en-

gine oil level displayed is correct, carry out
the check with the car on the level ground.

Fig. 85 refers to the display with an oil

level below the foreseen minimum. In this
condition the display shows the flashing bars
and the message “

OIL” for about 10 sec-

onds.

IMPORTANT In this case the correct en-

gine oil level should be restored as soon as
possible, see “Checking levels” in the “car
maintenance” chapter.

In case of fuel system failure, after turn-

ing the ignition key to 

MAR, the display

shows only the message “

OIL” flashing for

about 10 seconds (

fig. 86).

Fig. 87 refers to the display with an oil

level above the foreseen maximum. In this
condition the display shows the message
“

HIGH OIL”.

IMPORTANT In this case, contact Alfa

Romeo Authorised Services who will restore
the correct engine oil level.

fig. 84

A0A0711m

fig. 85

A0A0712m

fig. 87

A0A0714m

fig. 86

A0A0713m

058-085_Alfa147 Q2 GB  4-07-2008  11:59  Pagina 61