Albatron Technology DM-5952KF 用户手册

8 

 

【

∕

】

 

Note：Only for Rev.K-1 or higher. 

 

 

FIGURE 3：DM-XX52KF CONNECT WITH CT-1890/CT-1892 VISION CONVERTER 

9 

Monitor shall be placed at least 6 inches away from the obstructer. 
a. Monitor will work well when connect with computer and any high 

definition receiver. With a high definition resolution, Monitor is designed 
without video converter with it.  To work as a TV or using with VCR and 
DVD, you must to connect with a video converter.    

b.  The following descriptions are based on Monitor connected with video 

converter ready. 

【

】

 

 

 

1.  Install cable from antenna or cable TV to the “F” connector labeled “ANT 

IN”. 

2.  Press the Power ON, and the Red LED Indicator should be lit on the 

monitor, and the monitor is on STAND BY mode. 

3.  Press the POWER button on the Remote-controller; the Red indicator 

should turn into green. 

4. Press TV∕PC∕AV button or press TV button on Remote-Controller 

until the monitor displays MAIN NTSC TV. 

5.  To switch to TV∕CATV mode, select TV if you are using an antenna, or  

select CATV if you have a cable service. 

6.  Press AUTO button with your remote control, and Monitor will now 

preset all active channels into memory. 

7.  Selecting a channel. 

a.  Press CH▲

∕

▼

b.  Press the numeric key to select a desired channel. 

8.  Press VOL +∕VOL - to adjust the volume on remote control or the front 

panel. 

 

 

1.  To connect the signal by F Connector, following the instruction to setup 

your Television. 

2.  If using the Video (Composite) from the VCR, connect the Video input 

with Left, and Right Speaker. 

3.  Start the VCR. 
4.  Using the Remote control press TV∕PC∕AV button until or press 

VIDEO button until VIDEO appears on the screen. 

5.  If using the S-Video output of the VCR. Connect an S cable from the 

VCR to Monitor.