Agilent Technologies Microwave Oven 53150A 用户手册
Appendix C Using the Battery Option
Replacing the Batteries
Operating Guide
C-5
C
NOTE
The thumbscrews require a considerable amount of turning force, since
they pull the battery sled partially out of the Counter and also extract the
battery terminals from the battery connector as you turn them. To prevent
the battery sled from binding and increasing the force necessary to turn
the thumbscrews, either turn both thumbscrews simultaneously, or
alternately turn the thumbscrews one-half turn each, until both
thumbscrews are fully out of the threaded holes in the back panel.
they pull the battery sled partially out of the Counter and also extract the
battery terminals from the battery connector as you turn them. To prevent
the battery sled from binding and increasing the force necessary to turn
the thumbscrews, either turn both thumbscrews simultaneously, or
alternately turn the thumbscrews one-half turn each, until both
thumbscrews are fully out of the threaded holes in the back panel.
3
Slide the battery sled out the back of the Counter.
CAUTION
Avoid placing the battery sled and/or the batteries where the battery
terminals could contact any conductive surfaces.
terminals could contact any conductive surfaces.
4
Lift the terminal end of either or both batteries up out of the battery sled,
and then pull the battery(ies) out of the sled.
and then pull the battery(ies) out of the sled.
Installing Batteries
To install batteries in the Counter, use the following procedure:
1
If you have not previously removed the battery sled from the Counter and
the batteries from the sled, do so now (see “Removing the Batteries” on the
previous page).
the batteries from the sled, do so now (see “Removing the Batteries” on the
previous page).
2
Position the battery sled so that the back (taller) end is to your left as
shown in Figure C-3
shown in Figure C-3