AB Soft Snowplow 760HD 用户手册
Lit. No. B64090, Rev. 00
29
April 1, 2006
POWER HITCH™ SYSTEM INSTRUCTIONS
Prior to operating your straight blade snowplow,
review the Mounting and Dismounting Instructions
label on the back of the driver’s side moldboard.
review the Mounting and Dismounting Instructions
label on the back of the driver’s side moldboard.
NOTE: If at any time the Mounting and
Dismounting Instructions label, or any other label
attached to your snowplow become illegible,
promptly replace them.
Dismounting Instructions label, or any other label
attached to your snowplow become illegible,
promptly replace them.
CONNECT/DISCONNECT
Power Hitch Switch
Power Hitch Switch
Adjustable
Kickstand
Kickstand
Power
Hitch
Hitch
Slowly Back
Vehicle Away
Vehicle Away
A-Frame
Latch
Lock Pin
Latch
Lock Pin
A-Frame
Latch
Latch
Draw
Pin
Pin
A-Frame Latch
Rotates Clockwise
And Hooks Onto
Draw Pin
CONNECT/DISCONNECT
Power Hitch Switch
Power Hitch Switch
Adjustable
Kickstand
Kickstand
Power
Hitch
Hitch
POWER HITCH LOWERS FROM UNDERCARRIAGE PUSH BEAM.
CAUTION: KEEP FINGERS AWAY!
CONNECT/DISCONNECT
Power Hitch Switch
Power Hitch Switch
Push Beam
Receiver
Mount Points
Receiver
Mount Points
Adjustable
Kickstand
Kickstand
A-frame
Mount Bushing
Mount Bushing
Power
Hitch
Hitch
POWER HITCH RAISES BEHIND UNDERCARRIAGE PUSH BEAM.
CAUTION: KEEP FINGERS AWAY!
Undercarriage
Push Beam
Push Beam
Slowly Move
Vehicle Forward
Vehicle Forward
Connect electrical harness
plugs to mount plow and
disconnect plugs prior
to dismounting plow
• Kickstand should be in the lowered position.
• Slowly drive vehicle forward until the push beam receiver
mount points contact the A-frame mount bushings.
• Turn POWER HITCHOPERATION switch (on plow control)
to the "ON" position.
• Connect plow and vehicle electrical harnesses.
• Pull A-frame latch lock pin out and lower the latch over the draw pin.
• Push and hold the CONNECT/DISCONNECT switch upward. The Power Hitch
will engage the back of the push beam and pull the plow into the push beam
receiver mount points on the vehicle.
• Insert both hitch pins and secure each with a hair pin cotter.
• Lower Power Hitch to relieve tension on the A-frame latch. Raise the A-frame
latch into its locked position. Raise plow to the full up position.
• Raise kickstand until it locks into place. The plow is now properly mounted.
• Push and hold the CONNECT/DISCONNECT switch downward. The Power
Hitch will disengage from behind the undercarriage push beam and lower.
CAUTION: KEEP FINGERS AWAY FROM PLOW & TRUCK MOUNTING POINTS!
• Disconnect plow and vehicle electrical harnesses. Install weather caps.
• Turn SYSTEM POWER (on plow control) to the "OFF" position.
• Slowly back vehicle away from plow.
• With the plow fully raised, lower the kickstand.
• Lower plow on a flat, level surface. Turn vehicle ignition off.
• Remove hitch pins from the A-frame and undercarriage.
• Turn vehicle ignition on.
• Verify POWER HITCH OPERATION switch (on plow control)
is in the "ON" position.